Overhaul injection molding machine hinge (curved hand), injection molding machine maintenance, replacement, programming. Plastic injection molding machine,

Repair, etc.. Corinthians column custom, maintenance (feeder), change servo injection molding machines, injection molding machine plate slided repair, barrel drain glue repair, the tail plate high

Filter injection molding machine peripheral equipment:

Hopper, mold temperature machine, cold water machine, grinder, mixer (mixer), automatic suction machine, metal separators, lift pump, hopper slider (board), water separator, air dryer machine, dryer air pipe and so on. Dehumidifying dryer, cooling towers, the central feeding system, servo transformer, dust collector, magnetic frame, a screen, a blade grinder,

Filter Bao injection molding machine accessories and hardware electrical accessories:

Glue head (dispensing head, aprons, meson), nozzle, flange, mold clip, foot shock, heating pipe, heating coil, a sense of line temperature, warm needling, imports of electronic scale, cooler, high-pressure tubing, Teflon tubing, smoke discharging pipe, corrosion resistance high temperature wind pipe, oil lattice filters, rail steel sheet, sol motor, oil valve, proportional valve, variable pump, gear pump, electric injection molding machine special lube oil, cylinder, cylinder, oil seal, oil, oil, hydraulic station, release agent, anti rust agent, mold cleaning water and so on.

The operator must be familiar with and understand the function of the switch button on the operating panel of the injection molding machine, and operate according to the operation rules and points.

First, the operation requirements of the injection molding machine

1, in the injection molding machine heating start before production to open the cooling water valve, to observe whether the water flow.

2, close the power switch on the control box, connected to the power supply, according to the motor start button on the panel to start the oil pump motor.

3, initial use and for a long time not to use the injection molding machine, start the pump to the first few minutes of running empty, we can start to operate.

4, open the plastic injection molding machine heating switch, connected to the electric power, adjust the box door on the constant temperature and temperature control instrument, the temperature set, observe the size of the current meter, in order to determine the good or bad.

5, injection molding machine test should be manual and semi-automatic, automatic, in turn, at the same time should check whether the important fastening bolts are loose,